Peroxide Curable FKM Raw Polymer

Different from general Bisphenol curable copolymer, peroxide fkm shows better physical peroperties in higher tear resistance, better chemical resistance and better mechanical property.  
send email to us

Products Details

Peroxide curing FKM is terpolymer of hexafluoropropylene, vinylidene fluoride and tetrafluoroethylene. It has below properties compare with traditional bisphenol curable fluoroelastomer. * Excellent flow ability and mold release. * High tensile strength and anti rearing performance. * Rapid curing process. * Excellent agent resistant performance. * Good compressing set character.
Polyamine curing Bisphenol curing Peroxide curing
Curing agent Diamine Bisphenol TAIC

Application

● Fuel seal ● Fuel pipe ● Shaft seal ● Turbocharger tube ● Watch band

Datasheet

FDF351 FDF353 FDF533 FDP530 FDL530
Fluorine content % 70 70 70 68.5 65
Density (g/cm3) 1.9 1.9 1.9 1.85 1.82
Mooney Viscosity (ML (1+10)121℃) 70±10 40±10 45±15 50±10 40±20
Tensile strength after post cure (Mpa) 24h, 230℃ ≥18 ≥25 ≥25 ≥20 ≥20
Elongation at break after post cure (%)24h, 230℃ ≥230 ≥240 ≥240 ≥250 ≥240
Compression set (%) 70h, 200℃ ≤35 ≤20 ≤20 ≤25 ≤25
Application Extrusion fuel pipes, turbocharger tube Watch bands etc
How to choose fluoroelatomer? FKM Copolymer vs FKM Terpolymer Copolymer: 66% fluorine content, general application, resistance to oil, fuel, heat, chemicals. Common application is o rings, oil seals, packers, gaskets, etc. Terpolymer: higher fluorine content than copolymer 68% fluorine content. Better resistance to oil, fuel, heat, chemicals, used in harsh environment which copolymer can’t satisfy the requirements. Bisphenol curable FPM vs Peroxide curable FPM Bisphenol curable FPM has low compression set, offer used for o-rings, shaft seals, piston seals. Price is good. Peroxide curable FPM has better resistance to polar solvents, steam, acids, chemicals. Price is much higher. Its often used for wearable devices, extrusion fuel hoses. rth

Storage

Viton precompound should be stored in a cool, dry and ventilated place. Shelf life is 24 months since production date.

Package

1. To prevent the compounds stick to each other, we apply PE film between each layer of FKM compounds. 2. Every 5kgs in a transparent PE bag. 3. Every 20kgs/ 25kgs in a carton. 4. 500kgs on a pallet, with strips to reinforce. tyj

Previous:Quality General Purpose Fluoroelastomer Base Polymer - Direct from Our Factory!

Next:Low Compression Set FVMQ Compound

Fluoropolymer, HNBR material, Fluid resistant rubber, Ptfe Molding Powder, fvmq, fluorosilicone fvmq, Rubber Molding Compounds, Viton Spec Sheet, fluorosilicone rubber, Anel Oring Em Viton,

Featured Products

Contact us

Please feel free to give your inquiry in the form below We will reply you in 24 hours